25.08.2011  HTC Wizard 200 Unbrick – Boot repair supported

Resurrection of HTC Wizard 200 is simple. Battery must be connected in order to establish JTAG connection.
Current resurrector works with devices based on G4 MDOC chip.
Resurrector can repair IPL and SPL areas (which areas to repair you can select in popup window).
Please note: DiskOnChip G4 memory has security features, due to which there is a risk of permanently blocking the access to the flash memory while re-flashing the IPL area. Thus be very carefull not to interrupt IPL repair process (in case you have selected IPL area to be repaired).
In case your device has permanently blocked MDOC memory you will see this error:

****************************************************************
Detected a Not Initialized FLASH1 Chip ID: 0×0400/0xFBFF
ERROR: Selected FLASH Chip was not initialized by the DCC Loader
****************************************************************
This can happen due to unknown protection keys used or due to permanently blocked MDOC chip. If latter is true we advise you to solder a new flash memory chip or throw this phone away to the trash bin.
To resurrect HTC Wizard:

  •  Solder JTAG cable to HTC Wizard JTAG pads;
  •  Insert battery and connect USB cable to phone and PC;
  •  Make sure HTC Wizard is selected in the list of models;
  •  Press Power On key
  •  Click Resurrect button;
  •  Wait till software signals a successful operation completion;
  •  Disconnect USB cable, de-solder JTAG wires;

Now phone is in bootable condition, that is, even if it does not start up normally, you can flash it using known flashing methods.
To enter download mode:

  •  Disconnect PC cable;
  •  Insert battery;
  •  Hold ‘Camera’ key and press ‘Power ON’ button.

Please click “Check For Updates” button in order to download and apply new files. Closing all running application before starting update process is recommended.